New Year promotion
Now you will get a unique discount for SH5.CE
NOTE. Save the website address to get back to our offer because it is visible from special promotion only..
Foot Controller
Clean, Crunch, Drive, Boost and Mute.
Cabinet Simulator
4x12" cabinet with Celestion Vintage-30 .
Preamp
You can use Stomp-Head as a preamp without connection to cabinet.
Amplifier
This compact amp delivers enough loudness level for any stage size.
Power stage efficiency: 200Watt
Power output selector: 90W, 40W, 20W, 12W
Speakers impedance auto detection: 4,8 and 16ohm
Tubes: 12AX7
3 channels: CLEAN, Classic LEAD, High Gain LEAD
4 different sounds: CLEAN, CRUNCH, DRIVE, HIGH-GAIN
5 footswitches: CLEAN, CRUNCH, DRIVE, BOOST, MUTE
CLEAN CHANNEL controls:
BASS, MIDDLE, TREBLE, GAIN, VOLUME / switches: MID-RANGE BRIGHT
CRUNCH and DRIVE CHANNEL controls:
DRIVE, BASS, MIDDLE, TREBLE, VOLUME / switches: MID-RANGE BRIGHT-DARK
MASTER CHANNEL contlols: NOISE GATE, BOOST, MASTER
Input GAIN boost (switch +6dB)
MUTE
RESONANCE – switch increasing the sound in the resonance range of the loudspeaker
Serial EFFECT LOOP
LINE OUTPUT with Speaker Simulation. Allows send linear signal with simulation (PIN) or without simulation (RING) or both simultaneously
EXTERNAL CONTROLLER INPUT for channel selector and BOOST
Voltage selector 230V/50Hz or 115V/60Hz
Dimensions: (H x W x D) 90 x 330 x 205 mm
Weight: 2,45kg
Manual
873 590 EUR
The Taurus Stomp-Head 5.CE it is a fully analog design based on our own Master Tube Design technology, without any digital simulations.
The amplifier is extremely easy to use and contains everything that is necessary in a guitarist's workshop.
as a classic amplifier with a speaker cabinet.There are 4 power levels to choose from: 90W, 40W, 20W and 12W.
as a preamp connected directly to the mixer or sound system using output with built-in loudspeaker simulation.
SH-6.CE can be used in various configurations:
as a classic amplifier with a speaker cabinet.There are 4 power levels to choose from: 90W, 40W, 20W and 12W.
as a preamp connected directly to the mixer or sound system using output with built-in loudspeaker simulation.
Stomp-Head 6.CE as a pre-amp.
If you want to record your guitar or use the amplifier as a pre-amp without a cabinet then you have a special tool on board - an advanced loudspeaker simulator (IR-CAB simulation). You can choose accurate simulations of two types of speakers: Celestion Vintage-30 and Celestion Creamback.
The CAB-simulation is also equipped in adjustment for microphone position. It provides additional possibilities of equalizing the colour of your sound at the line output. Thanks to this solution you can get closer to the sound conditions of a classic set of speakers with a microphone setup.
You get the right placement and sound of the instrument in the band's mix by transmitting the signal from the line output without using the speaker. All this is done in an analog way, very simple and intuitive, without the use other additional processors. The line output has two signals paths, with or without simulation. This feature also allows you to connect an external loudspeaker simulator. So you can use the built-in simulation, external simulation or both of them at once.
Taurus Custom
SH
A
Designed by musicians for musicians